The content which follows involving Why Do My Plumbing Pipes Make A Knocking Noise is quite insightful. Read it yourself and figure out what you think of it.

To detect noisy plumbing, it is very important to establish first whether the undesirable audios happen on the system's inlet side-in various other words, when water is transformed on-or on the drainpipe side. Sounds on the inlet side have varied causes: extreme water pressure, worn valve and faucet parts, poorly attached pumps or various other devices, inaccurately placed pipe fasteners, and also plumbing runs including way too many limited bends or other limitations. Noises on the drain side generally stem from inadequate location or, similar to some inlet side sound, a design containing tight bends.
Hissing
Hissing sound that occurs when a faucet is opened slightly generally signals excessive water pressure. Consult your local public utility if you believe this trouble; it will be able to tell you the water pressure in your area and can set up a pressurereducing valve on the incoming supply of water pipe if essential.
Other Inlet Side Noises
Creaking, squealing, damaging, breaking, and also tapping typically are triggered by the growth or contraction of pipes, generally copper ones supplying warm water. The audios take place as the pipes slide versus loosened fasteners or strike neighboring home framing. You can typically identify the place of the problem if the pipelines are subjected; simply adhere to the noise when the pipes are making noise. More than likely you will find a loosened pipeline wall mount or a location where pipelines lie so near to floor joists or various other framing pieces that they clatter versus them. Connecting foam pipeline insulation around the pipelines at the point of call must fix the issue. Make certain bands and also wall mounts are secure and supply ample support. Where possible, pipeline bolts need to be connected to huge architectural components such as structure wall surfaces instead of to mounting; doing so reduces the transmission of resonances from plumbing to surface areas that can enhance as well as transfer them. If affixing fasteners to framework is unavoidable, wrap pipelines with insulation or various other resistant material where they call fasteners, as well as sandwich completions of new bolts between rubber washers when mounting them.
Remedying plumbing runs that struggle with flow-restricting tight or many bends is a last option that should be embarked on only after consulting a competent plumbing professional. However, this scenario is relatively usual in older homes that might not have been constructed with indoor plumbing or that have actually seen several remodels, particularly by beginners.
Chattering or Shrilling
Intense chattering or screeching that happens when a valve or faucet is switched on, which typically goes away when the fitting is opened totally, signals loose or malfunctioning inner components. The solution is to replace the valve or tap with a brand-new one.
Pumps and appliances such as washing devices and also dish washers can transfer electric motor sound to pipelines if they are improperly linked. Link such products to plumbing with plastic or rubber hoses-never stiff pipe-to isolate them.
Drainpipe Noise
On the drain side of plumbing, the chief goals are to eliminate surface areas that can be struck by dropping or hurrying water as well as to protect pipes to contain unavoidable audios.
In brand-new building and construction, tubs, shower stalls, bathrooms, and wallmounted sinks and also containers must be set on or against resistant underlayments to minimize the transmission of sound via them. Water-saving bathrooms and taps are less loud than conventional versions; install them as opposed to older types even if codes in your location still permit making use of older fixtures.
Drains that do not run up and down to the basement or that branch right into horizontal pipe runs sustained at flooring joists or other mounting existing particularly frustrating sound problems. Such pipes are big sufficient to radiate considerable vibration; they likewise lug substantial quantities of water, that makes the situation even worse. In brand-new building and construction, define cast-iron dirt pipelines (the large pipelines that drain bathrooms) if you can manage them. Their massiveness consists of much of the noise made by water passing through them. Additionally, prevent directing drainpipes in walls shown to rooms as well as spaces where people collect. Walls containing drains must be soundproofed as was explained previously, making use of dual panels of sound-insulating fiber board and also wallboard. Pipelines themselves can be covered with special fiberglass insulation made for the purpose; such pipes have a resistant plastic skin (sometimes having lead). Outcomes are not always adequate.
Thudding
Thudding sound, usually accompanied by trembling pipes, when a tap or appliance shutoff is turned off is a problem called water hammer. The noise and also vibration are caused by the reverberating wave of stress in the water, which instantly has no location to go. Sometimes opening up a valve that discharges water swiftly into an area of piping having a constraint, arm joint, or tee fitting can generate the same condition.
Water hammer can generally be cured by setting up installations called air chambers or shock absorbers in the plumbing to which the trouble valves or faucets are linked. These gadgets enable the shock wave created by the halted flow of water to dissipate in the air they have, which (unlike water) is compressible.
Older plumbing systems might have brief vertical sections of capped pipe behind walls on tap runs for the exact same function; these can eventually full of water, reducing or destroying their effectiveness. The treatment is to drain pipes the water system completely by shutting down the primary water system valve as well as opening all taps. After that open up the major supply valve as well as close the faucets one at a time, starting with the faucet nearest the valve and ending with the one farthest away.
If Your Plumbing is Making These Sounds, There’s a Problem
A Bang or Thump When You Turn Off a Faucet
If a loud bang or thump greets you each time your turn off running water, you likely have a water hammer. A water hammer occurs when the water velocity is brought to a halt, sending a shock wave through the pipe. It can be pretty jarring — even worse, damaging to your plumbing system. All that thudding could loosen connections.
Strange Toilet Noises
You’re so familiar with the sounds your toilet makes that your ears will be attuned to anything out of the ordinary. Fortunately, most unusual toilet noises can be narrowed down to just one of several problems.
Foghorn sound:
Open the toilet tank Flush the toilet When you hear the foghorn noise, lift the float to the top of the tank If you’re ambitious, you can remove the ballcock valve and disassemble it to replace the washer. Or you can more easily replace the ballcock valve entirely. This device is relatively inexpensive and available at most any hardware store.
Persistent hissing:
The hissing following a flush is the sound of the tank filling. It should stop once the tank is full. But if the hissing continues, it’s likely because water is leaking out of the tank. The rubber flap at the bottom of the tank can degrade, letting water slip through and into the bowl. That’s why the tank is refilling continuously. Fortunately, this is an easy fix:
Cut the water to the toilet by closing the shutoff valve on the water supply line. Flush the toilet to drain the tank. Disconnect the flapper Attach the new flapper Gurgling or bubbling:
Gurgling or bubbling suggests negative air pressure in the drain line, likely resulting from a clog. As air releases, it causes the water in the toilet to bubble. This could either be a minor issue or a major one, depending on the clog’s severity. Clogs can be caused by toilet paper or more stubborn obstructions such as tree roots. If you can’t work out the clog with a plunger, contact a professional plumber for assistance because a clog of this magnitude could lead to filthy and unsanitary sewage backups in your sink bathtub.

I found that page about Why is My Home Making Strange Plumbing Noises when surfing around the search engines. Sharing is nice. Helping people is fun. We recognize the value of reading our article about Why Do My Plumbing Pipes Make A Knocking Noise.
Stay calm, just ring.